4"x4" steel body 9" wide with plastic caps on each end
This is for using in a racing chassis so that the main steering unit is not in front of the monitor. It can also be used in an actual car simulator where the main steering unit is under the hood and the steering column extends into the driving compartment. It can have external electronic box and the steering column can be made to any desired length needed.
This setup can have up to 16 buttons and 4 Hall effect sensors. A small analog circuit board is mounted behind the button plate with an additional USB cable
This is a unit we built for the military to control a remote controlled vehicle. It has hand operated analog throttle and brake controls.
This is a custom built unit for a customer who didn't have use of his legs and wanted a unit he could operate from his recliner without having to have a desk or shelf in front of him. He held it in place by placing his legs on top of the padded extensions at the bottom of the unit. It has analog hand controls for Accelerator and brake like our EZ models.
This is a 2 pedal unit that we build for use in simulators. It can easily be mounted for floor mount or hanging pedals
This is a long shaft steering and pedal unit that the customer wanted for mounting in an actual sprint car chassis.
This is a small remote operated pedal unit that can connected to an actual cars pedals with push pull cables.
This is a steering controller built for the military using the actual steering column and steering wheel for mounting in an actual Humvee simulator.